Baby bronco 72 gets two more inches!!!!!

[orangecrush4u]

Last of the brake parts came in.... Maybe i will have it drivable this weekend, ohh wait not interor in

[orangecrush4u]

Gave the drivers side and Pass side a second coat, also installed one rear shock and Im thinking I should have went a little smaller.

[orangecrush4u]

Went over to the garage and measured and tapped off a line on the top rails where the hardtop and softop rest just so I don't have any wear issues. Sanded the areas and where the holes were and cold galvinised them. I also put some bond on the hartop where there was a hole and sanded it.



Floor came out great maybe I will finish that up tomorrow.

[orangecrush4u]

Gave the top rails and sides a coat, now the entire inside has one coat and the floor pans have 2


gave the roof on the top a light coat to see how it would look, I think its a go for the whole thing.

[joe]

cool

[orangecrush4u]

Went over to carquest and found all the right adapter to make my new setup work. I brought the master cyc and the prop valve and my lines so we knew what I needed. They had them all except on which they are dropping off for me at work after 3. Who knows maybe I can drive the truck in the next day or 2

[orangecrush4u]

Well the Carquest guy never showed up yesterday at work with the last peice to hopefully make the new system, going to call in a few minutes.

[orangecrush4u]

Just called carquest they forgot to dropp it off no big deal, at some point today with a order comming over to the rock.

[orangecrush4u]

my mess of brake lines....

[orangecrush4u]

The fitting got dropped off and I was able to dry fit it all, even better I was able to switch things around and use my flexable lines. Hope to asemble in the morn and bleed the system.