Lightin' it up

[ScruffMcGruff]

So I've got a set of accessory lights on my front bumper, and a switch for them on my dash. Problem is, the lights aren't connected to anything. They've got a plug on the inside of the bumper, seen here:
http://i.imgur.com/FoB1q.jpg
Any idea what I plug into with this? Or do I have to do some custom wiring myself?

Also, I'd like to get a light bar for my roof rack. What kind of light bar would fit on a KargoMaster Safari rack, like this one:
http://i.imgur.com/VyDYw.jpg
And how and where do I plug those in? Thanks for any help.

[Pugulis]

I'd say contact Hulu about the lights on the front. Didn't he say he built your Jeep? As for mounting light on the rack. You could go a couple of ways. You could find a light bar that fits it specifically. Or (I like this the best) build something. Either drill right into the tubing on the bottom and mount them there. Or get a piece aluminum (either tubing or angle stock) attach the lights to that and then bolt the whole thing to the front. You could also use PCV (check out my pic). As far as wiring goes, you also have a couple of choices. You could just run the wire through the door opening or drill a whole in the roof. Just make sure you seal it up good. There is a wiring diagram in the Helpful tech website section. Hope this helps.

[ScruffMcGruff]

I probably should have noticed the electrical and lighting section earlier, eh?

[gamble3527]

you can get brackets that mount directly to that roof rack, i have them and they work great

[ScruffMcGruff]

you can get brackets that mount directly to that roof rack, i have them and they work great

You know where I can get some?